Wonderfire Eclipse 654 Manual de usuario descargar pdf (Pagina 34)

INSTALLER’S GUIDE

Page 34

Figure 39. Smoke match tube position

12.2 Check for Spillage

A spillage check must be made before leaving the installed appliance with the

customer. Make this with all the ceramic pebbles in position.

1. Close all doors and windows in the room containing the appliance.

2. Light the appliance and set the control to the ‘High’ position.

3. Leave the appliance on for five minutes.

4. The smoke match should be placed horizontally into the hotbox at the right hand side.

(See figure 39).

The installation is satisfactory if the smoke is drawn into the appliance.

If the smoke is not drawn into the appliance leave the appliance alight at the maximum

setting for a further ten minutes and then

repeat the test. If the smoke is still not

drawn into the appliance inspect the

sealing to the fireplace surround. If the

sealing is satisfactory but the appliance is

installed with the flue restrictor (see

section 7 point 13) remove the restrictor,

reseal the appliance and retest. If smoke is

still not drawn into the appliance

disconnect the appliance and seek

expert advice.

5. If the above test is satisfactory open all

internal connecting doors, hatches, etc. in

the room. Keep all doors and windows

that open to the outside of the building

closed. Recheck for spillage as above. If

an extractor fan is installed in the same

room as the appliance or a connecting

room, check that spillage does not occur

with the fan operating and all doors and

other openings between the fan and the

appliance open.

If the smoke is drawn into the appliance, continue with the installation. If the test is not

satisfactory disconnect the appliance and advise the customer of the cause of failure.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

Sin comentarios

Wonderfire Eclipse 654 Manual de usuario Pagina 34