Wonderfire Eclipse 654 Manual de usuario descargar pdf (Pagina 33)

INSTALLER’S GUIDE

Page 33

12. FULL OPERATING CHECKS

12.1 Check the Control Settings

Please note:

• When first turned on from cold, the flames will appear predominantly blue.

• When operating the fire for the first time, some vapours may be given off which could

set off smoke alarms in the vicinity. These vapours are quite normal with new appliances.

They are totally harmless and will disappear after a few hours use.

1. Depress the control knob and rotate it anticlockwise to the pilot ignition position. A

‘click’ will be heard as the integral piezo operates. A flame should appear at the pilot to

the left hand side of the pebble base. When a flame appears at the pilot keep the control

knob depressed and hold the pilot ignition position for five seconds. When the control

knob is released the pilot flame should remain lit.

If there are no sparks check the spark gap between electrode wire and thermocouple tip.

See figure 23.

2. Turn the control knob anti-clockwise to ‘HIGH’ (Depress the knob slightly to get

past the pilot ignition position). The main burner should now light. Depress the control

knob slightly to release from the ‘HIGH’ position and turn back (clockwise) to ‘LOW’.

While turning, the burner flames should gradually become lower but remain alight.

Depress the control knob slightly to release from the ‘LOW’ position and turn back

(clockwise) to the Pilot ignition position. The main burner should extinguish but the pilot

should remain alight. Depress the control knob slightly and turn back (clockwise) to turn

OFF. This will extinguish the pilot.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 43 44

Sin comentarios

Wonderfire Eclipse 654 Manual de usuario Pagina 33