Wonderfire Eclipse 654 Manual de usuario descargar pdf (Pagina 18)

INSTALLER’S GUIDE

Page 18

6. Remove the two screws to the side

of the burner cover (See figure 10)

7. Detach the burner cover by lifting

clear of the burner module (See figure 10)

8. Remove the protective film from the

burner cover. Place the burner cover in a

safe place away from the work area.

9. Detach the burner unit from the

hotbox by lifting clear.

10. Fit the two “U” section seals to the

bottom edges of the hotbox side flanges.

See figure 11.

11. For concealed connection only:

There are two removable circular panels at

the rear of the hotbox. Decide which one

of these is to be used for rear entry.

Using a suitable tool apply pressure to

the centre of the removable circular

panel. There is a grommet in the

installation kit supplied with the fire. Fit

this into the hole. Pierce the grommet to

allow the pipe to pass through it. The

grommet should envelop the pipe. If the

hole is larger than the pipe, seal it with

tape. Do not pierce the grommet

unless the supply pipe is to pass

through it.

Figure 11. Fitting “U” Seals

Figure 10. Removal of Burner Module

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

Sin comentarios

Wonderfire Eclipse 654 Manual de usuario Pagina 18