Wonderfire Eclipse 654 Manual de usuario descargar pdf (Pagina 23)

INSTALLER’S GUIDE

Page 23

Figure 20. Lower Cable Retention

Figure 19. Floor Fixing

Figure 18. Cable Route

6. Thread the cables through the eyebolts. Return the

cables through the holes near the bottom of the hotbox

back panel, (For precast or clay block flue systems

return the cables through the slotted holes in the side

of the hotbox), and through the “V” shaped brackets

near the bottom front sides of the hotbox - See figure

18.

7. Place the hotbox fully back into the fireplace opening

so that it is sealed against the fireplace front surround.

8. Drill a hole into the fireplace floor through each of

the two holes in the base of the

hotbox using a no.12 masonry drill.

See figure 19.

9. Insert a fibre plug into each hole.

Use the fibre supplied with this

appliance - Never use plastic plugs

instead of the fibre plugs supplied.

Fit a woodscrew in each plug and

tighten.

Always screw the base into position

before applying tension to the cables.

This will ensure a tight seal between

the top of the hotbox and wall

10. Fit a cable retainer over the bottom

end of each cable.

11. Pull each cable taut. Push the cable

retainers hard up against the “V”

brackets. Tighten the screws in the

retainers so that they clamp the cables in

position. Apply tension to the cables by

turning the hexagonal adjusters by hand.

See figure 20.

12. Inspect the installation of the hotbox

against the fireplace surround. If the

hotbox is aligned squarely and the sealing is satisfactory, fully tighten the cable retainers.

13. If the hotbox is not correctly aligned, release the tension on the cables by slackening

the screws and turning the hexagonal adjusters fully anticlockwise. The hotbox should

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

Sin comentarios

Wonderfire Eclipse 654 Manual de usuario Pagina 23