Wonderfire Eclipse 654 Manual de usuario descargar pdf (Pagina 28)

INSTALLER’S GUIDE

Page 28

Figure 26. Identifying and

fitting decorative trims to the front

surround.

Figure 25. Front Surround Location

10. FRONT SURROUND INSTALLATION

1. Carefully lift the front surround.

Place the front surround against the fireplace

front surface so that the four retaining plates at

the back of the surround are directly above the

four retaining brackets of the hotbox. There are

two at the top of the hotbox and two to the side

of the burner module. Lower the surround unit

making sure that the retaining plates locate fully

into the brackets on the hotbox (See figure 25).

2. The front surround decorative trim is made

up of four sections. A bottom and top section of

equal length and two shorter sections of equal

length that are the side sections. These can be

identified as in figure 26.

2.1 Remove any protective film from the

trim sections

2.2 The trim sections are held in place

using 16 magnets. Position the magnets as in

figure 26.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

Sin comentarios

Wonderfire Eclipse 654 Manual de usuario Pagina 28