Wonderfire Eclipse 654 Manual de usuario descargar pdf (Pagina 31)

INSTALLER’S GUIDE

Page 31

4. There are four pebbles

numbered ‘1’ on the underside.

Locate these onto the pebble base

at the ends of the outer left and

right hand ceramic support rods

(See figure 33).

5. There are two pebbles

numbered ‘2’ on the underside.

Locate these on the pebble base

between the ends of

the inner left and right

ceramic support rods

(See figure 34).

Important note: The

gap between the

number ‘2’ pebbles

affects the final flame

picture. If the flames

tend to the sides of the

fuel bed then increase

the gap between the

number ‘2’ pebbles. If the

flames tend to the centre

of the fuel bed then

decrease the gap between

the number ‘2’ pebbles.

The amount of movement

may be as little as 3 –

5mm.

6. Pebble ‘3’ has a

location peg on the

underside. The peg has a

chamfer on one side. The chamfer must face the burner. Locate pebble ‘3’ onto the left

hand side of the pebble base. It should bridge the gap between the front and rear halves of

the pebble base. Pebble ‘3’ should not touch the burner cover (Figure 35).

Figure 35 Pebble number ‘3’ Location

Figure 34 Pebble number ‘2’ Location

Figure 33 Pebble number ‘1’ Location

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 43 44

Sin comentarios

Wonderfire Eclipse 654 Manual de usuario Pagina 31